| |
Specifications |
: |
Due to having anodic effect of the mettallic zinc, it has good chemical materials resistance and gives an excellent anticorrosive action. It is two component epoxy primer which prevents to becoming rust from under. When its applied 15-20µ dry film thickness on surface which is suitable to weld. |
|
|
|
|
Technical Features |
: |
Type of Resin : Coal Tar -Epoxy Resin / Polyamide Hardener
Specific Gravity (g/ml) (20°C) : 3.30 ± 0.10
Glossy : matt.
Solid Content (by weight) (%) : 90 ± 2
Solid Content (by volume) (%) : 66 ± 2
Active Corrosion Inhibitor in total solids (by weight) (%) : 95 ± 1
Flash Point ( °C ) : 22
Heat Resistance (Dry) ( °C ) : 150
Theoretical Coverage : 18 m²/l; 5 m²/kg ( 35 µ dry film thickness)
Practical Coverage : 3-6 m²/kg ( 25 - 50 µ dry film thickness)
Mixing Ratio (by weight) : I. Component : 95 / II. Component (Hardener): 5
Pot Life (20°C) : 8 - 12 hour.
Dry film thickness (one coat application) : 40 - 80 µ
Drying Time (20°C- Relative Humidity 65%) : First drying : 30 min. Drying : 1 -2 hours Second coat application : 10 - 12 hours Full hardening : 7 days
Thin Down Ratio : Depending on application method; it should be thinned with Merepoks Epoxy Thinner 5-10 % by weight.
|
|
|
|
Application 1 |
: |
Sand blasting Sa 2½ or Sa 3. All application surface must be clean, dry and free from oil. |
|
|
|
Application 2 |
: |
Epoxy Zinc Rich Primer Paint and hardener components should be mixed well observe to mixing ratio. 5-10 minutes waited after components mixing, Merepoks Zinc Rich Epoxy Primer Paint is applied on surface with brush or airless spray gun as one or two coats, allowing 10-12 hours between the coats. Due to its sagging easily, the epoxy mixture mixed constantly or should be transfered container form other container. |
|
|
|
Storage Conditions |
: |
It should be storaged in original and closed containers at 5 - 35 ° C temperatures for one year. It should be protected from extreme heat and moisture. |
|
|
|
Önemli Uyarılar |
: |
Two components must be mixed well.
The mixture should be prepared enough as small parts. The mixing ratio should be considered for paint wastage.
The ambient temperature should be between 5 – 35 ° C at the time of application
Application tools must be cleaned with Merepoks Epoxy Thinner, after the application,.
Paint doesn’t empty into drains.
Application procedures defined above should be strictly observed. |
|
|
|
Danger Warning |
: |
R 10 : Flammable. :
R 20/21/22 : Harmful by inhalation, in contact with skin and if swallowed. :
|
|
|
|
Emergency Warning |
: |
S 2 : Keep out of the reach of children. :
S 3 / 7 / 9 : Keep container tightly closed in a cool, well ventilated place. :
S 16 : Keep away from sources of ignition, no smoking. :
S 24 / 25 : Avoid contact with skin and eyes. :
S 29 : Do not empty into drains. :
S 46 : If swallowed, seek medical advice immediately and show container or label. :
S 51 : Use only in well ventilated areas. :
|
